- Length: 225mm
- Height: 70mm
- 100mm O-ring cut out
- White ABS plastic
- Rotary vent
- Low profile- 70mm high off sub-straight
- UV Stable ABS construction
- Stainless steel 304 components
- Stainless steel 304 fixing bolts
- Only 1 fixing bolt required
- Large 100mm cut-out for max-airflow
- EPDM UV stable soft seal O-ring
- O-ring able to take-up uneven surfaces
- Equipped with a rose vent that can open and close when needed
- Cut a 100mm diameter hole in substrate.
- Smooth down any loose or sharp edges and prime to prevent corrosion
- Place the rotary vent into the hole, making sure the EPDM UV stable O-ring is making full contact with the substrate. (Adhesive sealant can be applied behind the O-ring to prevent moisture egress).
- Working inside, select M8 20mm for thickness, 1mm - 1mm & M8 30mm for thickness 12mm - 20mm
- Working inside, place the bolt through the inner rose vent and screw into the rotary vents stainless steel threaded housing
- Once bolted in-place, clip the rose vent cover over the inner cover and adjust opening to your requirement.
- 4X4 Canopies